This is a stand that allows you to display the Transformers Siege Jetfire figure in action poses in either robot or airplane mode.

I saw a few other stands out there but they didn't allow for different poses and I really wanted to be able to see the full range of action for the figure without having to print a whole different stand for each one. This stand is modular, so you can swap the airplane adapter for the robot adapter and the base stays the same. There's a ball joint where the adapter connects so you can pick the angle for the pose you want and the stand should accommodate you.

This prints without supports and it all screws together.

Print one each of:

• Base
• Arm
• Robot Pack Adapter
• Airplane Adapter

Print two each of:

• Nut
• Ball

To assemble the adapters, put the ball through the nut such that you can screw the nut onto the ball socket, then insert the ball into the hole on the adapter. It's a friction fit, it's meant to be tight.

To assemble the base, screw the arm into the hole on the base.

Attach the adapter of your choice at the angle of your choice and tighten the nut down to the arm to lock the ball joint in place. Pose Jetfire in a cool way and place him on the stand. Done!