After learning of the fantastic Doodle Disc by @stringham and printing several for my daughter, I was surprised to not find a container for them or the holder. Also having not touched 3d modeling in 30 years, I dove in and created this!

This box holds both the disc holder as well as roughly 15 discs.

Both the box and the lid are designed to use 6x2mm magnets, though in my build testing I have also added small nubs on the lid to help secure it. Due to the nubs, it is possible that the magnets are not necessary. With both, there is enough resistance to hold the lid on with the container being at least half full! In case of too much resistance from printer tolerances, a small notch is present for using a fingernail/etc to help pry off the lid.

*Note that the magnets may need a small dab of CA glue to hold in place.

Hope you enjoy!