Bring a little fun to the bathroom with a Penguin Toothpaste Squeezer Stand—made to match the same idea as my giraffe version (a themed toothpaste holder/stand).

Two ways to print (pick what matters to you)

You’ll see two print profiles included, both PLA:

1. FULL_LAYERS (Solid Color All The Way Down)
   • Colors are printed through the full thickness wherever they appear.
   • Best if you care about the side/edge color looking “true” (not just the front face).

   • Downside: more color changes + more purging = more waste + longer print time.

      

2. TOP_LAYER (Color Only in the Top 0.8mm)
   • The model prints black for most of the height, and only does the colored details in the top 0.8mm.
   • Best if you want less waste and a faster print, while the front looks essentially the same.
   • Note: if you look closely from the side, you’ll see the body is mostly black beneath the top color layer.

       (At 0.2mm layer height, 0.8mm is about 4 layers of multicolor.)

Filament colors shown

• Black (body), White (belly/eye), Orange (beak/feet)

Safety/Disclaimer: 

• Provided “as is.” Not certified. No warranties. Use at your own risk.
• Verify fit/clearance before use. Do not use if it interferes with normal operation, safety features, or emergency shutoff.
• Inspect regularly; stop using if loose, cracked, warped, or damaged.
• 3D-printed plastics can deform with heat, UV, chemicals, or load—avoid high heat and harsh cleaners unless you know the material is suitable.
• If this model holds/uses a sharp edge or blade: handle with care, keep out of reach of children, and use only as intended.
• Keep out of reach of small children; small parts can be a choking hazard. Adult supervision recommended where applicable.
• Not affiliated with or endorsed by any brand mentioned; all trademarks belong to their respective owners.