I built a Sim Racing Wind Simulator and these are all the printed parts I used.

I did not create all the parts, some are straight from Maker World, some are downloaded and customized, some I created from scratch.

I run this via Simhub using the ShakeIt Wind setup.

Acknowledgements

Model that the control box is based on

Model that the Pro Micro mount is based on

Model that the 17mm ball socket mount is based on

120mm Fan to 76mm Duct Adapter

120mm Fan Grills

76mm Tube Vent Insert

Cable Clamps

T-Nuts

Additional Components / Parts Used

76mm Duct

PWM Fan Extension Cables

Power Jack Socket

120mm Fans

Pro Micro Board

1 x 5v 3amp power supply

USB C cable to connect to hub or PC

1 x M3 heat insert (for Pro Micro Mount)

1 x M3 screw (for Pro Micro Mount)

2 x small self tapping screws for control box lid

M4 screws, bolts and washers for attaching parts to extrusion using the T Nuts