Spielbox are small and lightwight boxes with a sliding lid that locks in tightly place. I mainly designed them for better Board Game storage but you can use them for anything!

To open, just press sideways on the lid where the 2 circles are. 

They are fast to print and very thin. However, they are strong and flexible, even though just printed in PLA. I did many many iterations until I got the settings right. I attached profiles but if you cannot use them please set the following:

Layer Height: 0,2
# of Outer Walls: 1

Outer Wall Thickness: 0,6

Detect Thin Wall → Check

If you printed Spielbox, please consider leaving a comment, as this will make me very happy :)