This heavy-duty rod holder is designed to be surprisingly strong even when printed in PLA, while remaining fully parametric to fit a wide range of rod diameters — without using any screws 🔩🚫

The geometry transfers the load deep into the base, reducing stress at the hook area and making it ideal for use with high-quality double-sided mounting tape. Perfect for renters, clean installations, or anyone who simply hates drilling holes.

⚠️IMPORTANT

Use CUSTOMIZE button to change the diameter of the holder so that it will match your need. Use anything between 10mm (0.4 inches ) and 30mm (1.2 inches)

⭐ Key Features

• 💪 Very strong design, even in PLA
  Reinforced geometry and smooth load paths prevent snapping at the hook–base junction.
• 📐 Fully parametric
  Adjustable to hold rods with diameters tested from 10 to 30 mm (0.4–1.2 inches)
• 🧲 No screws, no drilling
  Designed specifically for double-sided tape mounting (VHB-style recommended).
• 🧼 Clean & removable installation
  Ideal for walls, cabinets, doors, and flat surfaces.

🏠🔧 Possible Applications

This holder works great for holding or supporting:

• 👕 Closet rods (clothes, jackets)
• 🧻 Paper towel holders
• 🍽️ Kitchen roll holders
• 🚿 Shower curtain rods (cabins, RVs)
• 🪟 Curtain rods
• 🧰 Workshop & garage storage (PVC, aluminum rods)

If it’s cylindrical and within the diameter range, this holder will probably handle it 😉

🖨️ Recommended Print Settings

• 🧪 Material: PLA (PETG / ABS / ASA also work)
• 📏 Layer height: 0.2
• 🧱 Walls: 3
• 🌀 Infill: 15% (gyroid or cubic) or you can do more if you want it stronger.
• ⬇️ Orientation: check the print profile, for maximum strength do NOT print it flat to the bed.

🧲 Mounting Notes

• Use high-quality double-sided tape (VHB-type recommended)
• 🧽 Clean and degrease the surface before mounting
• ⏳ Apply firm pressure and allow the adhesive to fully cure before loading

⚠️ Notes

For maximum strength print in stand up with supports, print orientation matters a lot.