This unique luxurious designer lamp “The Arc,” is a great piece that will draw guests in to your space. The print is composed of three different parts the arc segments using a tight dovetail connections and the two base pieces, one male and female dovetail end points. I used a 16.4 foot light strip from amazon (link below) lining The Arc to provide illumination. The parts fit together tightly and may require some force. I always use a 3d printed Hammer with a small furniture floor pad stuck on the surface to pound the parts into place without damaging them (see example in photos).

Dimensions:

5.9 ft Tall 

6.2 ft Wide

(Elegoo PLA PLUS was used for my print)

Printed Parts:

Arc Segments - x 26 

Male Base Component - x 1 

Female Base Component - x 1 

Additional Parts

Screws - x 12 (size will depend on base board thickness)

Washers - x 12 (size will depend on base board thickness)

Light Strip - x 1 (https://www.amazon.com/dp/B09TDF46TY?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1)