nepenthes clock

You can sell this model, and all the models in the link above,
with a membership on Patreon.
ShaggiEzekio | Original 3D printed content | Patreon

Be sure to stop in and view my profile page to find more original models!

Here is a photo I designed and turned into a clock. This one is 170 mm in size and has a back that can be fitted with magnets.

Print at 100% infill with a layer height of 0.08mm and a base layer of 0.16mm

Swap Instructions:
    Start with Black
    At layer #9 (0.8mm) swap to Red
    At layer #11 (0.96mm) swap to Jungle Green
    At layer #14 (1.2mm) swap to Ivory White
    At layer #16 (1.36mm) swap to Red
    At layer #26 (2.16mm) swap to Black for the rest.

If you receive the message about overhanging regions during slicing, you can ignore it.

Descrição