A simple stand to raise the Apple Magic Keyboard. Angles the keyboard at approx 8°, lifts the back by approximately 18mm and the front by approximately 2mm.

Print 2 or 3 depending on the size of your keyboard.

2 support a full size Apple Magic Keyboard with Touch ID and Numeric Keypad without any problems.

Depending on your desk you might need to add some non-slip silicon dots to the bottom.

Update 4 JUL 24: Added print profile for version with a securing clip and charging cable cut out. I found the original version stretched a little over time and would fall off the keyboard when it was moved. The new version with the clip keeps the riser in place when the keyboard is moved around and has a cut out to allow the lightning charging cable to be plugged in while the riser is in place.