Cobra Head Scepter

This scepter is designed to be printed in 4 parts on a Bambu Lab A1 mini. All the parts can be assembled together just with the included printed-in threads. No extra pieces are needed, but superglue can be applied on the threads to make it permamently attached.

The thread on the snake head is standard M20. Also compatible with my SPQR Roman Scepter:

[https://makerworld.com/es/models/2299652-spqr-imperial-roman-scepter#profileId-2509732](https://makerworld.com/es/models/2299652-spqr-imperial-roman-scepter#profileId-2509732)

In this print file there is included a AMS multicolor version for colored eyes, but honestly I dont think it is worth the extra time and material. I used a red marker to paint the eyes in red, it worked yes fine over WINKLE golden PLA silk.

IMPORTANT: I recommend printing at least the pieces with male thread with 3 walls to make the thread stronger. Do not overtighten the trheads, it could break the male thread.

IMPORTANT 2: I do not recommend chaning the size of the pieces, as it would change the tolerances between pieces and might not joint properly

IMPORTANT 3. If you want to print the 3 conic pieces on the same plate, as it is prepared on this print file, I recommend you to lower all printing and moving speeds. Standard speeds may cause vibrations on higher layers that might cause the piece disattach to the plate and cause catastrofic printing failure.

Descrição