My first fully from scratch design! Part design suggestions, print profile suggestions, etc all welcome, just be kind. :D 

🔧 Alternate Version Available:
I’ve uploaded a drywall screw flush-fit version of this hook for easier mounting with standard hardware.

Check it out here: [https://makerworld.com/en/models/2439516-heavy-duty-wall-hook-drywall-screw-version](https://makerworld.com/en/models/2439516-heavy-duty-wall-hook-drywall-screw-version) 

A nice screwdriver to help mount it! → [https://us.store.bambulab.com/products/mini-screwdriver-toolkit](https://us.store.bambulab.com/products/mini-screwdriver-toolkit)
A great tool to clean up your hook if you use a brim → [https://us.store.bambulab.com/products/maker-s-supply-professional-trimming-tool-kit](https://us.store.bambulab.com/products/maker-s-supply-professional-trimming-tool-kit) 

This is a compact, low-profile wall hook / utility bracket designed for strength, clean mounting, and real-world use — not just aesthetics.

The design uses reinforced geometry, fillets, and chamfers to maximize durability while keeping material usage efficient. It mounts securely with two screws and provides a solid hook surface for everyday items like hats, gear, cords, or accessories.

Design Highlights

• Two-screw wall mounting for a secure, non-rotating install
• Triangular reinforced structure for strength without bulk
• Rounded edges & chamfers to add some design flair to a functional hook
• Compact footprint with excellent load distribution

Use Cases

• Hat hook (ball caps, snapbacks, trucker hats)
• Garage or workshop wall hook
• Hanging light gear, cords, headphones, or accessories
• Utility hook for closets, mudrooms, or storage areas

Printing Notes (Important)

• Orientation: Print flat on side. 

• Supports:

  • Supports are recommended for the front access hole to ensure clean overhangs and proper screw access
  • Use support blockers if your slicer supports them, or limit supports to “support critical areas only”

   

• Recommended material:

  • PLA+ for general indoor use
  • PETG or ABS for garages or warmer environments

   

• Layer height: 0.16–0.28 mm
• Infill: 20–30% gyroid, cubic or my favorite support cubic (strength and speed combo)
• Walls: 3–4 perimeters recommended for strength

⚠️ Disclaimer: Load capacity depends on print settings, material choice, wall anchors, and installation surface. Always test before hanging valuable or heavy items.