This is a stackable storage box designed specifically for wireless mice.

If you use multiple mice for work, gaming, or different devices, keeping them organized on your desk can be surprisingly difficult. This model allows you to neatly store and stack multiple mice vertically, saving desk space while keeping each mouse easy to access.

The side opening is designed with a large curve so you can smoothly take the mouse in and out without lifting the entire box. Each module can be stacked securely, allowing you to expand the storage height as needed.

Please check the inner dimensions before printing to make sure your mouse fits.
 

Features

• Stackable modular design
• Designed for wireless mouse storage
• Easy access with curved side opening
• Expandable by stacking multiple modules
• Clean and simple desk organizer

Inner Dimensions

• W80 × D122.5 × H55 (mm)

Assembly & Notes

• Two small holes are included to connect modules together
• Four holes on the bottom are for rubber feet
• Compatible with 10mm round rubber feet
• Rubber feet with a height of 2mm or more are recommended to prevent slipping when removing the mouse

Material

• The model shown in the photos was printed with PLA+

Note

• Support material is generated in the bottom holes for the rubber feet and should be removed after printing.
• This model is designed for wireless mice. Wired mice are not recommended due to the cable, which may interfere with stacking and storage.