Hi, 

I am posting another modification of the Keltec P17. This time it is a flat trigger, inspired by the mcarbo trigger.

Printed from matte PETG, layer 0.15, 50% infill, 4 perimeters. The print is slightly thicker than the original, so you need to use sandpaper (I used 250, 500, and 2000 grit) to achieve a thickness of about 8.2 mm. The holes may need a little calibration in the slicer. It is important that the pins fit loosely but not too loosely.The washers should be smoothed. I glued them to the trigger with superglue, which is not necessary but makes installation easier. 

The installation is well presented in this video, but I recommend starting by removing the mag release  with a screwdriver. 

[https://www.youtube.com/watch?v=dAT9A00cEbs](https://www.youtube.com/watch?v=dAT9A00cEbs)

I only dry-tested the trigger, but I won't be going to the shooting range anytime soon, so maybe someone else would like to test it.

Enjoy!