This is 4 colour Hueforge of Chichen Itza during sunset .

I uploaded two sizes 200x200 X1/P1/A1 and size 180x180 for A1 Mini.

And .STL with thicker version with no border size 200x200. Swap instructions down below.
 

    At layer #25 (2.08 mm) there is swap for black for the black border, but you can change the colour to any you like.

Do not adjust the thickness (Z) in your slicer!! The layers will not come out right. You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

If you want stand for this print check out my Simple vertical stand.
For my Hueforge pictures with border choose the version with 3 mm gap.

If you like this picture, you can look at my other pictures with sunset here in this collection: 

[https://makerworld.com/en/collections/8672734-sunset-hueforge](https://makerworld.com/en/collections/8672734-sunset-hueforge)

Instructions:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Blue Gray  Transmission Distance: 4
    PLA BambuLab Basic Orange  Transmission Distance: 6.4
    PLA BambuLab Basic Yellow  Transmission Distance: 5.6
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue Gray
    At layer #11 (0.96mm) swap to Orange
    At layer #18 (1.52mm) swap to Yellow for the rest.

    At layer #25 (2.08 mm) there is swap for black for the black border, but you can change the colour to any you like.
 

Thicker .STL

Swap Instructions:

    Start with Black
    At layer #10 (0.88mm) swap to Blue Gray
    At layer #13 (1.12mm) swap to Orange
    At layer #20 (1.68mm) swap to Yellow for the rest.