Two-part drip tray system for drying bath toys, dishes, or any items that need drainage. Water drips through a hexagon-pattern insert and collects in the base below, while ventilation holes on all four walls promote airflow and faster drying. The insert sits on an inset edge and a central support post built into the base.

Features

• Removable hex insert - Lifts out easily for cleaning; hexagon pattern provides excellent drainage
• Elevated drying surface - Insert sits 6mm above base floor, keeping items above pooled water
• 360° ventilation - 8mm holes on all four walls for airflow and faster evaporation
• Center support post - Prevents insert flex in the middle

Customization Parameters

• Width - Outer tray width in mm (default: 250)
• Depth - Outer tray depth in mm (default: 225)

Adjust width and depth to fit your printer's build plate or your specific use case.

Print Settings

• Layer height: 0.2mm
• Walls: 4 wall loops
• Infill: 15% gyroid
• Supports: None needed
• Layers
  • 4 top shell layers
  • 5 bottom shell layers
• Material: PETG (recommended) or PLA

Print both base and insert without supports. Base prints open-side up; insert prints flat-side up.