This universal 3D printed display stand is designed to support repurposed laptop screens, tablets, e-readers, picture frames, and flat displays with a thickness of 6.25 mm or less.

Unlike fixed-size holders, the stand grips the outside edges of the displayed item, allowing it to support nearly any width or height within reason. This makes it ideal for DIY monitor projects, digital photo displays, tablets, or showcasing artwork without needing a device-specific stand.

✅ Features

• Supports displays 6.25 mm thick or thinner
• Works with:
  • Repurposed laptop LCD screens
  • Tablets & iPads
  • E-readers (Kindle, Kobo, etc.)
  • Digital photo frames
  • Printed photos or artwork
• Universal width & height compatibility
• Stands sit on the outside edges of the display
• Minimalist design with a clean front profile
• No supports required
• Prints fast and clean

🖨 Recommended Print Settings

• Material: PLA, PETG, ABS, or ASA
• Layer Height: 0.2 mm
• Infill: 15–25%
• Supports: None
• Orientation: Print standing/upright

ASA or PETG is recommended for heavier displays or warm environments.

📦 Notes

• Designed for flat displays only (no hinge support)
• Device thickness must be 6.25 mm or less (unless scaled)
• Two stands are typically used (left & right)
• Not intended for large or heavy monitors

⚙️ Tips

• Print in PETG or increase infill for heavier screens
• Add adhesive rubber feet for extra grip
• Scale slightly if tighter or looser fit is desired