X1C/P1S Vented Led Riser

This is a Vented Led Riser, It allows you to have an LED strip on the top of the printer while also allowing you to vent out the hot air so you can keep your door shut while printing PLA!

This model may or may not be compatible with the new P2S I have not checked.

The assembly of this model is very simple and straight forward, just line up the numbers to each other, slide in the brackets, vent slider, and vent slider cap, and your good to go!

The Vent on the the front is adjustable, you can slide it to open or close, or to leave it half open if you like!

The LED strip is powered by a 12v power brick, powered by the mains voltage from your printers power supply, hidden in the back of the printer, where the cable is routed through the printer up to the front close to where the screen is, thats where your relay and switch connect to the printers original LED lamp power wires, and the new LED strip. This makes it so that the LED lamp and the LED Strip turn on together from your printer, no external Wi-Fi modules required!

I will not explain how to do this as i do not want someone without proper knowledge to attempt to make this. Ask someone who knows how to do these things to do it for you.

⚠️ Disclaimer: This mod involves internal wiring and mains voltage. Only attempt this if you understand what you are doing. I am not responsible for any damage caused.

Descrição

This is a Vented Led Riser, It allows you to have an LED strip on the top of the printer while also allowing you to vent out the hot air so you can keep your door shut while printing PLA!

I will not explain how to do this as i do not want someone without proper knowledge to attempt to make this. Ask someone who knows how to do these things to do it for you.

⚠️ Disclaimer: This mod involves internal wiring and mains voltage. Only attempt this if you understand what you are doing. I am not responsible for any damage caused.