I swear this time it's different!

Allow me to introduce another AMS wall mount. I have 4 AMS units and needed a way to move them away from my printers to reduce clutter. I searched far and wide for a solution and while there are many, I noticed that the AMS has had a few generations and all have different mounting points. Others have made many models to compensate for the various options, but I wanted something that just worked for all.

This project initially started off being built around the Ryobi Link Rail System. I did this because I had extra rails to use up and figured I could move the AMS around if I ever wanted to add or remove some. By the time I finished the design and testing the mounts, I realized most people would just want to mount this directly to the wall, so you will find two profiles included. One for the Ryobi Link System and one for direct wall mounting with screws.

I have been using these mounts for approximately 2 months now, with fully loaded AMS units and now some that use the Sunlu AMS Heater unit. GLUE IS HIGHLY RECOMMENDED DURING ASSEMBLY.

Please note*

I do not own a AMS 2 Pro. However, I used the measurements from Bambu's website when creating the mounts. According to the measurements found online, the AMS 2 Pro is 4mm wider than the original AMS. If you print this for the AMS 2 Pro, please share any feedback you have with me so that I may update the design if required.

If you want to create additional accessories for the mounts, please feel free to do so!

As always, share your experience with me and don't forget to boost!