Motorcycle Stand Pad

Hi all bike lovers!

I have seen a couple of kickstand pads but thought I would make my own and make it a bit thicker and more sturdy than a lot of the others. The pad is easy to take along or hang up on the provided hole it has. Should help your bike stand up when parked on soft underground, or use it to protect your flore when parked elsewhere/at home.

I printed the example Kawasaki pad in PLA, but if you tend to use it a lot outdoors in the sun, I recommend using PETG.

6 Walls, 50% infill, Gyroid infill pattern.

Takes about 2 hours in total to print and only uses about 44-45grams of filament.

On the front part (where the logo's are located) it is 5mm thick, and on the part where the stand sits it is 5.8mm thick. At the left and right riser it is 8.4mm thick. Height is 12.4cm and width is 7.8cm (widest part). Easy to take with you in luggage, jacket or even for some bikes under the saddle.

If you are still missing a brand, respond and I will see if I can add it.

Please leave me a comment.

Descrição