Project: Jinx.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 133.33x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.8mm and the Actual Thickness is 2.8mm

Filaments Used:  (* = Owned)
    #000000 * PLA BambuLab Basic Black  Transmission Distance: 0.1
    #00358e * PLA BambuLab Basic Blue  Transmission Distance: 4
    #0086d6 * PLA BambuLab Basic Cyan  Transmission Distance: 2.4
    #ffffff * PLA BambuLab Basic Jade White  Transmission Distance: 5.8
    #c00d1e * PLA BambuLab Basic Red  Transmission Distance: 3.7
    #fce300 * PLA BambuLab Basic Yellow  Transmission Distance: 5.2
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Blue
    At layer #8 (0.72mm) swap to Cyan
    At layer #9 (0.8mm) swap to Jade White
    At layer #14 (1.2mm) swap to Cyan
    At layer #16 (1.36mm) swap to Red
    At layer #20 (1.68mm) swap to Yellow
    At layer #21 (1.76mm) swap to Jade White
    At layer #25 (2.08mm) swap to Yellow
    At layer #27 (2.24mm) swap to Jade White for the rest.

For single AMS users, start with 4 colors as follows,
Slot1: Black
Slot2: Blue
Slot3: white
Slot4: Cyan
Pause was set at Layer 10 to allow color swap:
Slot1: Black --> Red
Slot2: Blue --> Yellow