Made to be simple and satisfying, this spin fidget focuses on smooth motion and easy assembly.

It consists of 3 parts and assembles in seconds. No glue is required, but a small drop can be used if you want to ensure the pin stays permanently attached. It works perfectly fine without it.

The design prioritizes reliability and feel over complexity, so it prints cleanly and spins smoothly straight off the printer.

Print info

• Simple 3-part design
• No supports needed
• Prints quickly on most printers (41 minutes on my Bambu Lab A1 mini)
• Tested with PLA, should work with most common filaments

I’m open to feedback. If you print it or have ideas for improvements, feel free to leave a comment.

(You can skip inserting the pin for a louder ratchet sound, since it will move freely and collide more with the sound element)