This is a mini basket, mostly for ultrasonic watch making cleaning, but it could be used for any type of jewerly. This remix allows you to pause the print before the bottom gets covered and insert the wire mesh, then after the base stops printing youll also need to pause the print to install the side wall mesh, so theyll end up caught in the print and you wont need to glue anything. The same happens with the top, as it allows you to pause the print before the threat starts to print and insert the mesh.

Mesh sizes:

• Body bottom mesh 29mm diameter
• Body mesh 11mm x 94mm
• Top mesh 33mm

Try and use the samallest mesh you can find, as with 1mm mesh, some screws may have a chance to fly out.