Bed Side Table 

This is my second design. I needed a table for my bedside, so rather than buying one, I decided to make my own. I hope you like it.

The motivation to make my own design was the amount of filament needed to make a single table for the existing designs on Makerworld. This one only uses very little filament. The dimensions of the table are 25cm x 25cm x 15 inches.

NOTE: You will need a 0.5 Inch Inner Diameter standard PVC pipe around 30 Inches. [Amazon link](https://www.amazon.com/FlowGuard-CPVC-Resistant-Residential-Commercial/dp/B0FTJ8B164/ref=sr_1_2?crid=29SDMK3NTJQPO&dib=eyJ2IjoiMSJ9.omGD6-T6opwLQkkjhiTPqXGgOGLxjMYQzWgowfF5nLVuC7l7MXSEcSGmrIUaU-zbfCZCI2qDlwnCmDl7L3szD7VyNRtxKbZvSqyGJBKuh6o.ZAdaORA28SZULsgAA6--qJtlR6ydOBM15uN0wIshFT0&dib_tag=se&keywords=half%2Binch%2Bpfc%2Bpipe&qid=1768234985&sprefix=half%2Binch%2Bpvc%2Bpi%2Caps%2C309&sr=8-2&th=1)  AS WE WILL BE NEEDING 4 Pieces of 15 Inches.

<Here is a quick guide on how to assemble it once finished.>

This is how all the printed parts and PVC pipe should look.
 

Start with the Table base, as shown in the image below.
 

Take the Tabletop and put it on top of the base, aligning the holes.
 

Flip the assembly and place it on a flat surface, then press firmly, and both the table top and table base will snap together.
 

We are almost there. Put the legs on the Base.
 

At the end, put the end caps on the legs.