LiteGrip Trainer

Triangle hangboard for finger training. Available in two models, each with three different edge sizes: 10-12-15 mm and 18-22-25 mm.
Fuzzy skin to improve grip.
Supports up to 50 kg. I personally tested it with my weight (68 kg), and it held without any issues.
Compatible with paracord or other types of rope.

I recommend printing it with PLA Basic. Keep in mind that PLA Matte is slightly weaker under tensile loads. PETG or PLA Tough+ should also work fine.
Weight: 65 g / 2.3 oz

This hangboard is a unique creation, born from my own idea. While it may look similar to other models on MakerWorld, it has been carefully engineered to be lighter without sacrificing strength. Every aspect of its design is focused on achieving maximum load capacity with minimal material, because plastic is cheap but not free.
The only element I drew inspiration from is the cable pass-through you can see in this model: [https://makerworld.com/it/models/1147276-textured-triangle-hangboard?from=search#profileId-1150783](https://makerworld.com/it/models/1147276-textured-triangle-hangboard?from=search#profileId-1150783) the idea this guy had for the cable is amazing, shout out to JA Design for that. Here is his makerworld page: [https://makerworld.com/it/@JA_Design](https://makerworld.com/it/@JA_Design)
Make sure to use the proper technique when training with it. Improper use may lead to injury.