Long Back Scratcher

Long Back Scratcher (505mm)

I previously made a long back scratcher, but the sleeve-joint structure was not very secure. It was also relatively thick and uneven.

This time, the shaft has been redesigned to reduce the diameter while maintaining strength. Grooves were added near the claw section, making it less prone to breakage.

A hand-grip recess has been added at the tail end, allowing you to easily feel and identify the orientation of the claw while scratching.

Overall length: 505 mm

All structural parts have been reinforced. The handle features a 16 × 16 mm octagonal profile.

Assembly requires glue.

All parts are support-free for printing. A brim of approximately 10 mm is recommended.

Descrição