Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
These are wall mounts designed to hold either one or two NES controllers. The holes are designed to hold 8mm counter sink screws but you could use nails or something smaller if you needed.
The single controller mount has the NES logo on the front lip that holds the controller in place and the double controller mount has the NES logo on the back plate.
As you can see in the images, you can mount the controllers with the cables sitting behind them or with the cables wrapped around the mount itself. I prefer the look of the cables going around the mount because you can see the logo easier and the controllers lay back a bit which is a little more aesthetic.
Check out the SNES controller mount I made too! [https://makerworld.com/en/models/2189255-snes-controller-wall-mount#profileId-2376841](https://makerworld.com/en/models/2189255-snes-controller-wall-mount#profileId-2376841)
