This version of a skateboard mount allows you to display your deck at any angle, including on angled walls or even ceilings.

The system is made up of two separate parts:

• a wall plate, and
• a deck bracket

This design means you don’t need perfect alignment during installation. It also lets you easily swap decks or change their order later without tools.

Installation Instructions

1. Prepare the parts
   • Tap all mount holes with an M5 thread.
   • This can be done by hand—no power tools required.
2. Attach bracket to the deck
   • Fix the brackets to your deck with both brackets facing the same direction.
   • Either orientation is fine, as long as they match.
3. Determine wall spacing
   • Measure the distance between the two brackets on the deck.
   • This measurement is the spacing you’ll drill for the wall plates.
   • If mounting multiple decks, measure them all and use the average spacing—it’s easier to keep the wall plates consistent than to adjust each one.
4. Fix the wall plates
   • Attach the wall plates using flat-headed screws.
     • Countersunk screws will work, but you’ll lose some adjustability.
     • 8 × 1 screws provide extra adjustment range.
   • Do not fully tighten the screws yet.
5. Final alignment
   • Measure the exact bracket spacing on the specific deck you’re mounting.
   • Adjust the wall plates to match this spacing.
   • Fully tighten the wall plate screws.
6. Mount the deck
   • Slide the deck onto the wall plates.