This holder for small 46mm cans was created for multiboard.io mounts.

It gets fixed with a single Small Thread Point Bolt, below the mount is a small nipple which avoids that the holder is able to rotate, this way only a single bolt is needed. I prefer to print the holder with support, but it prints also well without.

Needed Thread Point Bolt - Folded Version:

[https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Folded%29-1123334](https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Folded%29-1123334)

Thread Point Bolt - alternative Version with Support:

[https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Supported%29-1470815](https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Point%20%28Supported%29-1470815)