PLEASE BE CAREFUL REMOVING THE PARTS FROM THE PRINT BED, THEY MAY SNAP UNDER PRESSURE!!!

This is printed in ABS which is recommended, However, PLA will work fine without tweaking any settings in the slicer. Beware that depending what GPU you have and how much heat it creates, The bracket may warp, deform, or melt if printed in PLA. Please wait for the bracket to be cooled down before taking it off the build plate. I do not recommend printing it on Sport or Ludicrous mode. 

To prevent scratches on your GPU while installing, Turn the screw in the thread until the top of the screw reaches the bottom of your GPU, then SLIGHTLY Un screw the bracket and SLIGHTLY lift your GPU, and place the bracket under your GPU. 

BE CAREFUL NOT TO PUT THE BRACKET ON A FAN ON YOUR GPU AS IT MAY CAUSE SCRATCHES OR DAMAGE!!!