Hello everyone! This is my first model that I have published on Maker World, I hope you enjoy! This printer torture test is very lightweight and quick-printing. Can your printer take the challenge? it can be printed in around 40 minutes on normal settings and only takes up 14g of filament! The test includes: A bed adhesion and levelling test, a pin-cone challenge, an overhang test, a retraction/stringing test, a detail and model accuracy test, a vertical letter test, and a bridging test in 3 different sizes. I recommend to print this model with around 7-15 percent infill and a layer height of 0.2mm. I plan to release loads more models in the near future, so if you enjoy, it would help if you could boost me for free. Thank you very much! P.s sorry about the warping in the photos, I peeled it off the bed too soon.