The ultimate stand for the ultimate Helldiver. John Helldiver himself would have one of these. 

No AMS required as parts are separated out. Base does have objects that are easily painted with the fill paint options for more details if you like to add more color. For 2 colors on the plaque simply set a pause print at the appropriate layer height and manually change the color, then re-start your print.

Multiple height options available to fit your needs / headset size.

Images shown have the 150mm tall "top rod" screwed directly into the base. This worked for my headset when they are not extended. My headset fully extended I needed the 50mm extension added to the base so it would hang. 

Depending on your headset you may need to add extensions to either not hit the controller or raise it above the controller.

Controller portion does hold / support ps4 and Xbox controllers. I tested it with the controllers I had and seemed to fit well.

Printed on P2S

*Base is just small enough to fit on an A1 mini plate!

Print profile is basic settings.

.2 layer height

I used no supports, printed with basic PLA.

Required for Assembly:

• 4x - 8mm X 2mm magnets (if you are using the plaque)
• Glue for the skulls

Assembly:

• Top rod is press fit into the Headset cradle. Tolerances are tight for secure fit but still can be turned so the skulls face forward.
• Top rod can be screwed directly into the base, then align the headset cradle so it is facing forward.
• Extension rods are provided if you need the headset higher to clear the back of the controller or go above the controller. 50mm,75mm,100mm & 150mm provided. * The higher you go the more top heavy it becomes.
• Skulls can be glued into the recessed areas on the base & headrest cradle.
• Plaque mount is press fit into the front facing fin (first 2 slots closest to the base.) Also a tight fit, feel free to glue it if you like.
• Glue in 8x2 magnets in the plaque mount and the plaque.

CLICK HERE FOR MORE HELLDIVERS SWAG o7