Hey team! 

This has been one of the most asked about design when people start playing around with our clickers. I always get asked if there was a light up option. I've seen a few being sold online but there was no option to DIY a 3d printed one. Not anymore! I am proud to say that we are releasing this 3d printed design first here at TeamGraphika to top up 2025!

Please check the youtube tutorial for the full assembly below

I updated the alphabet and the base for this particular design, the base is entirely new, it's 2mm taller than the original and the internals have been redesigned to fit the led switch assembly. You can use the new base for just the regular clickers if you don't plan to print different types of base but you cannot use the led assembly on the previous version of the base. Hope that makes sense.

🗒️ Notes:
• These models need strong bed adhesion to ensure the best possible results. We recommend washing your build plate with soap and water before printing (or follow your printer manufacturer’s cleaning guide for a deep clean).

The led assembly is built with tight tolerances — no need to resize anything. In fact, resizing is discouraged, as it may cause the assembly to not fit properly. And make sure your printer is also calibrated to get dimensional accuracy.

✅ Bed Adhesion Tip:
These models need strong bed adhesion to ensure the best possible results. We recommend washing your build plate with soap and water before printing (or follow your printer manufacturer’s cleaning guide for a deep clean).

🔧 Materials needed for this project:
Battery: CR1220, other sizes will not fit this design
LED: 3mm or 1.8mm led diode, 5mm will not fit this design
Switch: Outemu or Drinkey switches, other switches may also work but I haven't tried them.

Ways to support my work & Commercial License

• Give this model a like - it helps promote it to people!
• Boost this model - if you enjoyed and printed it. This will help inspire me to continue making more models.
• Sell Physical Prints of my Models - Subscribe to my Patreon Membership so you can sell physical prints of my designs 
  You may also want to slow down the speed for silk filaments to give that chrome effect.

Check out my other models as well

[https://makerworld.com/en/@jeromebayawa](https://makerworld.com/en/@jeromebayawa)

Don't forget to tag me when you post online! I'd love to see what color variations you come up with.

Enjoy!