✅ Features

• Designed for 6mm round or D-shaft potentiometers
• Optimized for DIY audio amplifiers & boombox builds
• Lightweight but durable design
• Easy press-fit (no set screws required unless stated)
• Clean, modern look that complements custom enclosures
• Ideal for Bluetooth amps, Class-D boards, and DSP builds

🧰 Recommended Use

• DIY Bluetooth boomboxes
• Tool box speaker builds
• Custom amp cases
• Electronics enclosures
• Replacement knobs for budget amp boards

🖨️ Print Recommendations

• Material: PLA / PLA+ (PETG recommended for high-heat environments)
• Layer Height: 0.2mm
• Infill: 20–30%
• Supports: Not required
• Orientation: Print flat for best shaft tolerance

⚠️ Notes

• This listing is for 3D printable files only (unless otherwise stated).
• Fit may vary slightly depending on printer tolerances—test fit recommended.
• For personal use only unless you have a commercial license.
• Amplifier, potentiometer, and electronics not included.
•