Version 3 is out!! Its new and improved featureing a SnapLock Hinge.

VERSION 3 LINK: [https://makerworld.com/en/models/2612099-v3-harbor-freight-pick-box-print-in-place-snaplock#profileId-2882681](https://makerworld.com/en/models/2612099-v3-harbor-freight-pick-box-print-in-place-snaplock#profileId-2882681)

This is a latching box made for the set of 4 Harbor Freight Picks. The original packaging is flimsy and does not hold up inside a tool bag. This Pick Box lets you keep your picks safe and organized in your tool bags. I recommend using petg as that's what I printed my model with. The hinges use M4 hardware and the locking latch uses filament as its hinge.

Recommended material: PETG

Required hardware: 2x M4*20 screws/bolts

                                     2x M4 Nuts

                                     2x M4 Washers

Assembly:

1. Insert the bolts into the hinges and then put a washer and nut on the other end. (Using Loctite to prevent the nuts from backing off is recommended). 

2. Use a piece of filament for the hinge of the locking latch. If experiencing difficulty pushing filament all the way through, you can also use two pieces of filament and just push them in from both ends of the latch

If you like this model please boost it since it would help me out a lot!