This is a wall mount for the Nintendo Switch 2 specifically designed for the Dbrand Killswitch Dock adapter. It was designed to ensure proper airflow for the main dock and provides access to all of the ports included in the dock itself. The dock & adapter fit snugly and take a little bit of finesse to work them in, but i assure you it's a proper fit. To get the dock seated you will have to tuck the front of the adapter underneath the two front tabs and then wedge the rear of the dock into place. These front tabs not only keep the dock in place, they are designed to fix the issue with the Killswitch adapter unseating when pulling the switch off of the dock. I've found that after tucking the front in place, you can place your thumbs on the sides of the rear portion of the adapter and press down firmly while pulling the dock towards you at the same time. The dock, along with the adapter, should snap into place. The screw holes are 5mm in diameter with a 2.5mm beveled edge so your screws can fit slightly recessed as to not scratch the dock. Below i have attached photo illustrations along with captions to assist with installation. If you have any suggestions to make this model better, please do not hesitate to reach out. Thanks!

NOTE: This print requires supports to print properly.