📦 ESP32 Bluetooth Jammer Case

This is a custom-designed case made specifically for the exact components used in the YouTube video linked below.
 

🔗 Original electronics project (YouTube):
[https://www.youtube.com/watch?v=fdLniWPArmw](https://www.youtube.com/watch?v=fdLniWPArmw)
All credit for the electronic design goes to the original creator. This upload only provides the enclosure.

The fit is precise and has been tested with a real print before publishing.

🖨️ Recommended print settings

• Material:
  ✅ PETG strongly recommended
  PETG handles long-term use and potential heat from the ESP32 much better.
  PLA will work, but it’s not recommended if the device is used for extended periods.
• Layer height: 0.16 mm
• Perimeters:
  • Standard: 2-3 walls
  • ⚠️ First layer with only 1 wall (important for proper fit)
• Infill: 10–15% 
• Supports: ❌ Not required
• Print orientation: As uploaded (no rotation needed)
   

🔩 Hardware

• Screws:
  • M4 × 16 mm
  • Self-tapping into plastic

  • No heat-set inserts required

     

🧰 Post-processing

• Not required, but recommended:
  • 🔧 A deburring tool or small drill bit for the holes
  • Helps screws fit more smoothly and improves overall finish

• No sanding or extra adjustments needed

   

ℹ️ Additional notes

• Designed for:
  • Clean fit
  • Easy assembly
  • Fully tested with a physical print
• Matches exactly the parts shown in the video, no generic resizing or adaptations