Tired of scrambling through remotes on your coffee table? This wall-mounted holder keeps every clicker within reach of the device it controls. The model is customizable with 11 parameters, so it can grip remotes of almost any shape, height, or size. Other wall mounts exist, but they tend to be simple boxes with only basic width, height, and depth adjustments. Many remotes are not symmetrical front to back, so a fully tailored fit looks and works better than a plain cubby. I’ve included a printable sample for a Roku remote, and the customization page walks you through the five-minute measuring process with clear visuals so you can adapt the mount to any remote you own.
 

In your slicer position the model on it's foot. No need for any supports, brim, etc.
Once you have customized, and printed it, you could attach it to a vertical surface either with screws (hence you have two holes), or with a 3m command strip. The flat portion of the rear is hard coded for 20mm width and if you print it at 75 mm height minimum, it will accommodate a 3m commander strip size large.  Please double check that the bottom screw hole is visible through the front opening, or you won't be able to drive a screw through it. 

Any material is fine. My Roku pint profile would take roughly 20 grams and take about an hour to be printed.
For any questions or if you have questions report here or message me directly.

Tips on successfully generating your own mount:
1. Start with your required height as a step 1 (holder_height)

2. Front_centre_distance should be at least 1 mm longer than front_side_distance, otherwise the model will break

3. Same as point 2 for rear parameters - rear_centre_distance vs rear_side distance

Note: sometimes due to some specific dimensions the generation might break the model. If it occurs to you and you are pretty sure in your dimensions, please contact me and I will generate a print profile for you or double test the generation. I have personally witnessed such case when the holder_width was too small (43mm) for the rear_centre_distance to be reduced to 10mm.