Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 108x170mm in size

PLA Black

PLA Grey

PLA BambuLab Basic Red

PLA BambuLab Basic Pumpkin Orange

PLA BambuLab Basic Sunflower Yellow

PLA BambuLab Basic Jade White

This print uses 6 unique filaments

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Grey

At layer #14 (1.2mm) swap to Black

At layer #16 (1.36mm) swap to Red

At layer #19 (1.6mm) swap to Pumpkin Orange

At layer #24 (2mm) swap to Sunflower Yellow

At layer #27 (2.24mm) swap to Jade White for the rest.

Frame Version:

At layer #31 (2.56mm) swap to Pumpkin Orange for the rest.

If you only have one AMS, you can print it in 4 colors using these settings, but it won't turn out as detailed:

PLA Black

PLA BambuLab Basic Red

PLA BambuLab Basic Sunflower Yellow

PLA BambuLab Basic Jade White

Swap Instructions:

Start with Black

At layer #16 (1.36mm) swap to Red

At layer #24 (2mm) swap to Sunflower Yellow

At layer #27 (2.24mm) swap to Jade White for the rest.

Frame Version:

At layer #31 (2.56mm) swap to Red for the rest.

If you wish to enlarge this project, you can freely scale the X and Y axes. However, it is crucial to keep the Z height at 100% (do not change it). This ensures that the filament color swaps remain at the correct layers; changing the height will break the color sequence and ruin the final result.

Please note that using different brands or colors than those listed may change the final look, so I cannot guarantee the same result. Additionally, I strongly advise against using Silk filaments as they will likely ruin the effect.