My wife hated all of my work boots and cowboy boots just laying around the bedroom and I did not want to buy any old boot holder off Amazon and I have no room for a fancy horseshoe boot holder.

So I designed this.  Works great, still testing in out and might make a version 2 and combine 2 holders on the same print.

Prints with no supports, I did 4 walls, Detect thin walls and 12% Adaptive Cubic.  It has recessed screw holes, so any size screw should work.

I added a sizer on the 2nd plate or it comes combined on the STL (you just have to “CUT” the 2 apart and arrange accordingly).

The sizer is the same size as the file, print it, make sure it fits your boot as you would like, adjust scale as needed, reprint to check fit again, adjust Holder size to make what works for you and Bob's you Uncle.

Also found out it fits the metal tumblers like RTIC, Yeti and the other variations.