Recommended for Photoshoots, Meetups and Display

1/7/26  Update

After testing out the helmet at Holiday Matsuri the visibility issues were a huge issue for walking around solo.

So I'm only recommending the helmet for photoshoots and display. I will be making a new helmet for walking around but it will not be nearly as accurate.

Tin Master Helmet and I Pod + Cable Accessories.

Tin Master has a round helmet and to keep the look as accurate as possible the compromise ended up being poor visibility. Tape the faceplate on before you glue it in or paint it, to check for visibility because you might want to drill 2 small holes at the bottom of it.

Make sure to check where the mustache will glue on and mask that area off so you get a good bond later.

The Back of the helmet comes off with magnets D6x3, there is also a slot on the ears for magnets if you want the cable to disconnect with magnets. The Cable holes are ¼ inch (6.25mm)

Added a Print Profile for my Nametag it uses 4 of the same magnets.

Optional Parts

Ipod & cable accessories

Coffee

Arm Air Tanks

Dm me if you want to buy an apron.