V6 Engine block cooler

This is my V6 engine block cooler. Perfect for backyard get-togethers. The engine block is sliced into 4 sections so that it can fit on the P1 and X1 printer. There is also a drain plug (I used TPU to make). Holds six drinks, can or bottle. The tolerances are tight and will require you to seal the seams unless you do not mind melting ice to run out from the bottom or sides.

Note:

PETG for engine

TPU for drain plug

Support required

My V8 Version: [https://makerworld.com/en/models/236157#profileId-252311](https://makerworld.com/en/models/236157#profileId-252311)

Koozie: [https://makerworld.com/en/models/411911#profileId-313818](https://makerworld.com/en/models/411911#profileId-313818)

Descrição