Stack and/or join Ikea Lack tables to create your own configuration.

There are three components to the system:

1. ) A single corner stacker consisting of male and female part. I suggest fastening the males to the top surface of the lack table, and female to the bottom of the legs.

2.) A dual corner stacker for use when connecting side by side lack tables consisting of male and female part. I suggest fastening the males to the top surface of the lack table, and female to the bottom of the legs.

3.) A connector piece for under the top surfaces of the two lack tables joined together.

I suggest screwing and gluing the stacker parts to the Lack (drill pilot holes for the screws). Wood glue works fine. Screws I used are listed below.

The connector piece can be installed with just screws.

Screws for the Male stackers #12 x 1": [https://boltdepot.com/Product-Details?product=2504](https://boltdepot.com/Product-Details?product=2504)

Screws for the Female stackers and Connector pieces #12 x 5/8": [https://boltdepot.com/Product-Details?product=2502](https://boltdepot.com/Product-Details?product=2502)

Here are some more links to the components I used to make my system:

Ikea Lack Table: [https://www.ikea.com/us/en/p/lack-side-table-white-30449908/](https://www.ikea.com/us/en/p/lack-side-table-white-30449908/)Table 

Table top: [https://www.walmart.com/ip/Alera-AL-Reversible-Laminate-Table-Top-White-Gray-48-x-24-in/5091505968?classType=VARIANT&athbdg=L1700&from=/search](https://www.walmart.com/ip/Alera-AL-Reversible-Laminate-Table-Top-White-Gray-48-x-24-in/5091505968?classType=VARIANT&athbdg=L1700&from=/search)

And… here is a link to the 3D printed filament racks I made to fit between the legs of the Lack tables: [https://makerworld.com/en/models/1356174-filament-spool-rack-fit-to-ikea-lack-tables#profileId-1399885](https://makerworld.com/en/models/1356174-filament-spool-rack-fit-to-ikea-lack-tables#profileId-1399885)

NOTE: Some may think the lack tables are not sturdy enough for this application, but with them linked together and topped with the sturdy table top they work fine. I've successfully printed nearly 6,000 hours with my X1C on this setup.