Tree Strap Bow Hanger

Simple, lightweight bow hanger designed to work with tethered hunting/tree straps. Just feed the top loop through your strap loop and pull the arm through—no metal hardware, no noise. Can also be used with any paracord or rope loop around a tree.

Features

• One-piece printable bow hanger
• Top loop designed to feed through tethered/tree strap loops
• Works with paracord, rope, or webbing loops
• Long arm keeps your bow off the ground and away from the trunk
• Small stop at the end helps keep the bow from sliding off
• Quiet, lightweight, and easy to pack in your hunting kit
• Field tested in negative temperatures holding an Elite Ritual compound bow through the season

Printing

• Recommended material: PETG or ABS/ASA for outdoor use (PLA is fine for light/indoor use)
• Layer height: ~0.2 mm
• Infill: 30–40% (or higher for extra strength)
• Walls/perimeters: 3–4
• Print on its side for best strength along the arm; light supports under the curved loop if needed

Use & Safety

• Intended for hanging a bow or similarly light gear only
• Not for climbing or supporting body weight
• Always inspect for cracks or damage before use and retire if it shows any stress