After I got myself this fantastic electric screwdriver from Amazon I thought about “where to put it?” so I simply made myself a case for it. 
 

What is it doing?

• It fits the screwdriver nice and snug without grabing it too hard
• It has bit storage for up to 20 bits with a design that gives enough room to fit most brands of bits since they are pretty often not the same size with differences up to 0.2mm (tested it with all bits I had around from Makita, DeWalt, Snapon Hazet and for sure the no name ones that came with this screwdriver from Amazon) and leaves still a bit room to the bottom for when it gets used over time.
• The bit extension stays in place with a magnet to keep it nice in position without flying around but easy to remove
• The lid has compartments where you can sort small parts, screws, etc. while screwing.
• The text in the lid is inserted in Bambu Studio so you can adjust it/ remove it as you like when printing it. 

What parts do I need?

• 4x M3x30mm (if you can get 26mm or cut it down it will sit flush)
• 4x M3 nuts
• 2x M3x16mm or x20mm
• 1x 6x3mm magnet (and some glue to glue it in)

Installation

• slightly press in the nuts in the hexagon spaces at the rear hinges
• place the upper and lower case so you can put the hinges between them (the side with the bigger chamfer faces to the bottom/ outside)
• screw in your M3x30 till the nuts getting fully pulled inwards. 
• place the closing lid at the front hinge and screw the M3x16's in from both sides