There are thousands of deburring tool box. I just want to try one that you can fully printed requires no screws or magnets.

This design requires two pieces of filaments to function as the hinges. 

The main hinge needs a piece of filament with length of 103mm to 108mm (the longer the better but don't exceed).

Close the lid and insert the filament through the starting hole on the side of the hinge.

The starting hole may need to be enlarged a little due to the printing condition.

Use another section of filament to push the hinge filament fully into position and it won't fall out again.

The lock hinge needs a piece of filament with length of 31mm to 36mm.

Inserting instruction is the same as above.