Eufy Camera Mount – 90 degree angle 
Eufy Camera Mount with a 90 degree angle.
Designed for the Eufy S220, but it can also be used for other Eufy camera’s with the same type of mount. 
 

Specifications:
The original mount can not make a 90 degree angle, this upgrade resolves that issue. 
Most parts of the original mount are still used, except the newly printed part (black part), shown on the images. 
(Watch out, if you put the camera on the side of a wall you can still not reach the complete 90 degree angel because the camera is too large for that.)

Installation:
The upgraded part must be tightened till it is hand-tight.
Not the entire screw thread is needed of the upgraded part.
(Watch out, if you tighten the upgraded part to tight in the original mount, the upgraded part may break.)
 

Filament:
The upgraded part is printed in Bambu Lab ABS Black (40101).
Bambu Lab ABS White (40100) can be used to let the upgraded part blend in with the rest of the mount and camera.
Make sure to use a weather resistant and strong filament such as ABS/ ASA.