update Dec09,2025 : change poses of the horses, a bit easier taking off supports

new one on the left side

took me a while to make this one

I try PLA/PETG , PLA/ PLA support

after two days of testing print, I gave up and redesign the horses, lol

still a bit challenge for remove the support around the horses

but isn't as bad as my original design

you can do it :P

other then that, it should be fairly easy

PS. try avoiding Silk filaments for the pillar part, it would make your life 10 times harder, lol

use this gear to break the center column freely 

install the small gear here 

make sure everything moving smoothly 

personally I would add glue for attaching this part, my little girl just couldn't stop trying to take it apart

it should be alright without glue if no one abuse it

push it in with two finger, thats the hardest part