This bottle organizer has the following features:

• Holds three bottles up to 90mm in diameter each
• Sleek, modular design so you can stack them seamlessly 
  • See the photo where I have 2x side by side for storing up to 6 water bottles
• Recessed screw hole for added strength 
  • Note: for empty bottles a strong double sided tape may be enough. For full bottles like wine I suggest tape and screws (you can add more screw holes!)
• No supports required and uses <400g of filament so you should be able to print two from a single spool
• Can be printed on a single X1C build plate 

There are a lot of bottle organizers out there but I made this because I wanted something with a more sleek look that I could stack in a modular approach. It uses more filament than others but doesn't have a bunch of holes and you can still get 2 from a single spool