Rotating Display Stand

This is an easy to print and assemble USB C powered turntable model.

Whole  is only 4cm high❗️

Printing guide 📖

Print all parts from any material in any color you want. I printed everything from black PETG. 

Use supports for the main body and bottom.

2 or 3 walls and infiil 5 - 15% is enough.

Non-printed parts you need:

N20 motor with a angular gear 3mm diameter shaft. - I used a 13 rpm

The mount is for a 33mm long motor.

10x15 push button switch

USB C socket - 2 pin

3x1 neodymium magnets - 8pcs

M3 screws and nuts - 2pcs

After printing all the parts, proceed as follows ⬇️

Place the switch and USB socket into the housing by pressing them in ⬇️

Place the motor in the printed mount ⬇️

Glue the magnets into the holes.

Screw the motor to the main body with two M3 screws.

Connect black wires together.

The red (+) wire from the USB port to the switch. On the other side of the switch connect the red wire from the motor ⬇️

Close the lid and connect the USB-C cable.

Enjoy your new Display Turntable❗️

❗️Be careful when connecting soldered components. If you don't have the knowledge, don't do it. Remember, you do it at your own risk.❗️