Buc-ee’s Woggle Printing and Assembly Instructions

The Buc-ee’s woggle prints in three separate parts:

1. Woggle blank (Plate 1)
2. Buc-ee’s face (Plate 2)
3. Neckerchief loop (Plate 3)

Print the woggle blank and Buc-ee’s face face-down on the build plate to capture the plate’s textured surface.

After printing the woggle blank, remove the support material from the recessed area where the face will be inserted. The Buc-ee’s face should snap into place once the supports are cleared.

The neckerchief loop also snaps into the slots on the back of the woggle blank.

For best results, secure both the face and the neckerchief loop with a small amount of superglue.